|English German French Spanish Russian Portuguese|
|Hard Disk setup in BIOS|
Hard Disk setup in BIOS
The important BIOS parameters in the Hard Disk setup are maximizing the likelihood of the system functioning. Setting the BIOS can help to expose problems in a system. The Auto detects Hard Disk will entry in the BIOS setup menu for auto detecting your hard disk and uses it. Auto detecting of hard disks have auto detection as an option in the Standard Settings menu, where the hard disk parameters themselves are enter the standard settings menu and configure the following options: If you successfully auto detected your hard disk in the previous step then you should see the hard disk parameters in the BIOS displayed here.
These parameters are discussed in this section. If your system does not have a separate auto detection menu item, it probably auto detects devices by pressing Enter. This should normally be set to user for hard disks. If your system has it, then set this to for your CD-ROM drive. This is calculated and not something you can enter. This is supported by most hard disks but should be disabled for maximum compatibility. PIO Mode: This can normally be left at whatever the BIOS detected. However, if the BIOS set it to a value that you know exceeds the maximum for the drive, reset it to whatever the maximum is. You may want to try lowering this value if you experience problems with your system. CD-ROMs generally have a maximum PIO mode of 3.
The other methods of hard disk setup in BIOS are to set advanced features and enter the advanced features menu and configure the following options: Virus Protection and Virus Warning. This should be enabled at all times. If disabling this is required for stable operation, you probably have a motherboard hardware problem. It may also be a CPU problem, especially with processors that have integrated level 2 cache.
First, boot disk will work properly. You’re your floppy drives and make sure whether this is set correctly or you are going to be mighty confused about the behavior of your floppy disk drives. You can disable this at first when setting up a new system, or if you are experiencing hardware or system problems. Note however that if you totally disable power management, this will also eliminate some advanced power features such as the ability to have Windows turn off the PC on an ATX form factor system.
As an alternative, leave power management enabled but disable the standby/suspend timing parameters so that the BIOS does not automatically turn off parts of the system after a period of time. Integrated IDE / Hard Disk Controllers: Some will also have a device on the secondary channel. You will normally want this enabled, and the standard resource setting with I/O address. You will usually want this enabled, and the standard resource setting with I/O address. If you don't need it, plan to install a modem configured using default resources. Integrated Parallel Port: You will normally want to enable this. Do not set it to ECP, as this mode involves the use of additional DMA resources and is less compatible. There are other various methods of hard disk setup in BIOS, which offer the reliable one in order to setup the BIOS in your disk without creating a major problem for the system.
|Hard Disk Troubleshooting | Hard Disk Buying Guide | Hard Disk Data Bus | Hard Disk Formatting|
|Data Recovery Program | Disk Eraser | File Recover | Flash Card Recovery | Hard Disk Recovery Tools | Hard Drive Recovery
Picture Recovery Software | Recover Deleted Email Folders | Repair pst File | Undelete Formatted Hard Drive
|Corruption Recovery Tool | Data Recovery Companies in USA | PC Optimization Tools | Freeware Downloads|
|Copyright © 2006 Hard Disk Home. All Rights Reserved. www.harddiskhome.com|